Setting the RIP triggered update interval

Perform this task to avoid network overhead and reduce system resource consumption caused by frequent RIP triggered updates.

You can use the timer triggered command to set the maximum interval, minimum interval, and incremental interval for sending RIP triggered updates.

For a stable network, the minimum-interval is used.
If network changes become frequent, the incremental interval incremental-interval is used to extend the triggered update sending interval until the maximum-interval is reached.

To set the triggered update interval:

Step	Command	Remarks
1. Enter system view.	system-view	N/A
2. Enter RIP view.	rip [ process-id ] [ vpn-instance vpn-instance-name ]	N/A
3. Set the RIP triggered update interval.	timer triggered maximum-interval [ minimum-interval [ incremental-interval ] ]	By default: The maximum interval is 5 seconds. The minimum interval is 50 milliseconds. The incremental interval is 200 milliseconds.

Step

Command

Remarks

1. Enter system view.

system-view

N/A

2. Enter RIP view.

rip [ process-id ] [ vpn-instance vpn-instance-name ]

N/A

3. Set the RIP triggered update interval.

timer triggered maximum-interval [ minimum-interval [ incremental-interval ] ]

By default:

The maximum interval is 5 seconds.
The minimum interval is 50 milliseconds.
The incremental interval is 200 milliseconds.

prev	up	next
Configuring RIPv2 message authentication	home	Specifying a RIP neighbor