Bidirectional control mode
To use BFD bidirectional control detection between two devices, enable BFD control mode for each device's static route destined to the peer.
To configure a static route and enable BFD control mode, use one of the following methods:
Specify an output interface and a direct next hop.
Specify an indirect next hop and a specific BFD packet source address for the static route.
To configure BFD control mode for a static route (direct next hop):
Step | Command | Remarks |
---|---|---|
1. Enter system view. | system-view | N/A |
2. Configure BFD control mode for a static route. |
| By default, BFD control mode for a static route is not configured. |
To configure BFD control mode for a static route (indirect next hop):
Step | Command | Remarks |
---|---|---|
1. Enter system view. | system-view | N/A |
2. Configure BFD control mode for a static route. |
| By default, BFD control mode for a static route is not configured. |