Enabling the RIB to flush route attribute information to the FIB
This feature is available only for BGP routes in the current software version. You can configure this feature when using sFlow to monitor BGP traffic. For more information about BGP path attributes and sFlow, see Layer 3—IP Routing Configuration Guide and Network Management and Monitoring Configuration Guide.
To enable RIB to flush route attribute information to the FIB:
Step | Command | Remarks |
|---|---|---|
1. Enter system view. | system-view | N/A |
2. Enter RIB view. | rib | N/A |
3. Create the RIB IPv4 address family and enter its view. | address-family ipv4 | By default, no RIB IPv4 address family exists. |
4. Enable the RIB to flush route attribute information to the FIB. | flush route-attribute protocol | By default, the RIB does not flush route attribute information to the FIB. |