Configuring other parameters
Step | Command | Remarks |
---|---|---|
1. Enter system view. | system-view | N/A |
2. Enter T1 interface view. | controller t1 number | N/A |
3. Configure a description. | description text | The default is interface name Interface. |
4. Configure the framing format. | frame-format { esf | sf } | The default is esf. |
5. Set the line coding format. | code { ami | b8zs } | The default is b8zs. |
6. Set the cable type. | cable { long | 0db | -7.5db | -15db | -22.5db | short | 133ft | 266ft | 399ft | 533ft | 655ft } | The default is long 0db. |
7. Set the interframe filling tag type. | itf type { 7e | ff } | The default is 0x7E. |
8. Set alarm thresholds. | alarm-threshold { ais { level-1 | level-2 } | lfa { level-1 | level-2 | level-3 | level-4 } | los { pulse-detection | pulse-recovery } value } | By default:
|
9. Enable loopback and set the loopback mode. | loopback { local | payload | remote } | By default, loopback is disabled. |
10. Restore the default settings for the T1 interface. | default | N/A |
11. Bring up the T1 interface. | undo shutdown | By default, a T1 interface is up. |