Enabling PCM pass-through
The following matrix shows the feature and hardware compatibility:
Hardware | PCM pass-through compatibility |
---|---|
MSR954 (JH296A/JH297A/JH298A/JH299A/JH373A) | No |
MSR958 (JH300A/JH301A) | No |
MSR1002-4/1003-8S | No |
MSR2003 | No |
MSR2004-24/2004-48 | No |
MSR3012/3024/3044/3064 | Yes (supported only on E&M interface modules.) |
MSR4060/4080 | Yes (supported only on E&M interface modules.) |
This feature is supported only when G.711 A-Law is used. For this feature to take effect on a subcard, you must reboot the subcard. To check whether this feature takes effect, use the display device verbose command.
To enable PCM pass-through:
Step | Command | Remarks |
---|---|---|
1. Enter system view. | system-view | N/A |
2. Enter voice view. | voice-setup | N/A |
3. Enable PCM pass-through. |
| By default, PCM pass-through is disabled. |