Configuring the volume adjustment function
To configure the volume adjustment function:
Step | Command | Remarks… |
---|---|---|
1. Enter system view. | system-view | N/A |
2. Enter E1/T1 interface view. | controller { e1 | t1 } slot-number | N/A |
3. Create a TS set according to the selected signaling mode. | timeslot-set ts-set-number timeslot-list timeslots-list signal { e&m-delay | e&m-immediate | e&m-wink | fxo-ground | fxo-loop | fxs-ground | fxs-loop | r2 } | N/A |
4. Exit E1/T1 interface view. | quit | N/A |
5. Enter voice subscriber line view. | subscriber-line slot-number:ts-set-number | N/A |
6. Configure the input gain on the voice interface. | receive gain value | Optional. The default is 0. |
7. Configure the output gain on the voice interface. | transmit gain value | Optional. The default is 0. |
IMPORTANT: Gain adjustment might lead to a call failure. Hewlett Packard Enterprise recommends not adjusting the gain. If necessary, make sure you understand the impact of the adjustment on your call before you adjusting the gain. | ||