Configuring analog E&M line failure tone
As shown in Figure 12, E&M analog control signals pass-through is enabled for the analog E&M line on Router A. To notify an IP network failure or a peer failure to the Tone Generator, configure Router A to play busy tones for analog E&M line failure by using the em-failure busytone command.
Before performing this task, make sure that both the E&M non-signaling mode and the E&M analog control signals pass-through are enabled for the E&M line. For more information, see "Enabling E&M non-signaling mode" and "Enabling E&M analog control signals pass-through."
To configure analog E&M line failure tone:
Step | Command | Remarks |
---|---|---|
1. Enter system view. | system-view | N/A |
2. Enter voice subscriber line view. | subscriber-line line-number | N/A |
3. Configure analog E&M line failure tone. | em-failure { busytone | silence } | Optional. The default setting is silence. |