Configuring start mode

1. Enter system view.

system-view

N/A

2. Enter voice subscriber line view.

subscriber-line line-number

N/A

3. Configure the immediate start mode for the E&M voice subscriber line.

em-signal immediate

The default is immediate start mode by default.

4. Configure a delay before the originating side sends DTMF signals in the immediate start mode.

delay send-dtmf milliseconds

Optional.

The default is 300 milliseconds.

1. Enter system view.

system-view

N/A

2. Enter voice subscriber line view.

subscriber-line line-number

N/A

3. Configure the delay start mode for the E&M voice subscriber line.

em-signal delay

N/A

4. Configure the delay signal duration in the delay start mode.

delay hold milliseconds

Optional.

The default is 400 milliseconds.

5. Configure the delay time from when the terminating side detects a seizure signal to when it sends a delay signal in the delay start mode.

delay rising milliseconds

Optional.

The default is 300 milliseconds.

1. Enter system view.

system-view

N/A

2. Enter voice subscriber line view.

subscriber-line line-number

N/A

3. Configure the wink start mode for the E&M voice subscriber line.

em-signal wink

The default is immediate start mode.

4. Configure the delay time from when the terminating side receives a seizure signal to when it sends a wink signal in the wink start mode.

delay send-wink milliseconds

Optional.

The default is 200 milliseconds.

5. Configure the maximum amount of time the originating side waits for a wink signal after sending a seizure signal in the wink start mode.

delay wink-rising milliseconds

Optional.

The default is 2,000 milliseconds.

6. Configure the duration of a wink signal sent by the terminating side in the wink start mode.

delay wink-hold milliseconds

Optional.

The default is 500 milliseconds.