Configuring CID
Step | Command | Remarks |
---|---|---|
1. Enter system view. | system-view | N/A |
2. Enter FXS voice subscriber line view. | subscriber-line line-number | N/A |
3. Enable CID on the FXS voice subscriber line. | cid display | Optional. Enabled by default. |
4. Enable the FXS voice subscriber line to send calling identity information to the remote end. | cid send | Optional. Enabled by default. |
5. Configure the calling name for the FXS voice subscriber line. | calling-name text | Optional. Not configured by default. |
6. Configure the format of messages (which carry the calling number information) transmitted over the FXS voice subscriber line. | cid type { complex | simple } | Optional. The default is complex. When the peer end supports only one message format, you must use the same message format at the local end as the one used at the peer end. |
7. Configure the standard for the FXS voice subscriber line to send messages carrying the calling number information. | cid standard-type { bellcore | brazil } | Optional. By default, bellcore is adopted. |