Creating an EtoFR translation mapping
When you create an EtoFR translation mapping, follow these guidelines:
The interface specified by interface-type1 interface-number1 can only be a Layer 3 Ethernet interface, Ethernet subinterface, or VLAN interface.
The interface specified by interface-type2 interface-number2 can only be an FR interface/subinterface or MFR interface/subinterface.
You cannot change the link layer protocol of an FR interface in the EtoFR translation table.
In the EtoFR translation table, you can create only one entry for an Ethernet interface, and one entry for each DLCI on an FR interface.
The remote IP addresses of the interfaces in an EtoFR translation entry, or ip-address1 and ip-address2 must be located in the same network segment.
To create an EtoFR translation mapping:
Step | Command | Remarks |
---|---|---|
1. Enter system view. | system-view | N/A |
2. Create an EtoFR translation mapping. | etofr translate interface interface-type1 interface-number1 interface-type2 interface-number2 dlci dlci-number ip-address ip-address1 ip-address2 | No EtoFR translation mapping exists by default. |