Enabling IPoE and setting the IPoE access mode

1. Enter system view.

system-view

N/A

2. Enter interface view.

interface interface-type interface-number

This feature supports the following interfaces:

• Layer 3 Ethernet interface and subinterface.

• Layer 3 aggregate interface and subinterface.

• L3VE interface and subinterface.

3. Enable IPoE and set the IPoE access mode.

• Enable IPoE and set the IPoE access mode on an IPv4 interface:ip subscriber { l2-connected | routed } enable

• Enable IPoE and set the IPoE access mode on an IPv6 interface:
  ipv6 subscriber { l2-connected | routed } enable

By default, IPoE is disabled.

To change the IPoE access mode, disable access IPoE, and then set the new IPoE mode when you enable IPoE.