`show ubt state`

Syntax

show ubt state [uac-ip <UAC-ADDR>]

Description

Shows the UBT state.

Command context

config-ubt-<ZONE-NAME>

Parameters

uac-ip <UAC-ADDR>: Specifies the IP address of the user anchor controller for which to view user information. Specify the address in IPv4 format (x.x.x.x), where x is a decimal number from 0 to 255.

Authority

Operators or Administrators or local user group members with execution rights for this command. Operators can execute this command from the operator context (>) only.

Examples

Showing UBT state:

switch# show ubt state
Local Master Server (LMS) State:

LMS Type      IP Address    State
-----------------------------------------------------
Primary     : 10.10.10.148 ready_for_bootstrap
Secondary   : 10.10.10.147 ready_for_bootstrap

Switch Anchor Controller (SAC) State:

              IP Address      MAC Address          State
-----------------------------------------------------------------
Active      : 10.10.10.148    00:5a:5e:a3:75:21    Registered

User Anchor Controller(UAC): 10.10.10.148

User               Port    State                          Bucket ID  Gre Key
----------------------------------------------------------------------------
a4:b3:25:cb:50:ba   2/1/3  registered                     33         67

Showing user information on the UAC with IP address 10.10.10.20.20:

switch# show ubt state uac-ip 10.10.10.20.20

User Anchor Controller(UAC): 10.10.10.20 
User                          Port       VLAN    Gre Key   State 
--------------------------------------------------------------------------- 
00:00:0a:1a:12:03             11/1/5     400     2         registered