show loop-protect
Syntax
show loop-protect [<INTERFACE-NAME>] [vsx-peer]
Description
Shows loop protection information for all interfaces or for a specific interface.
Command context
Operator (>
) or Manager (#
)
Parameters
<INTERFACE-NAME>
Specifies the name of a logical interface on the switch. This can be one of the following:
An Ethernet interface associated with a physical port. Use the format
member/slot/port
(for example,1/3/1
).A LAG (link aggregation group). Specify the ID of LAG . For example:
lag100
.
[vsx-peer]
Shows the output from the VSX peer switch. If the switches do not have the VSX configuration or the ISL is down, the output from the VSX peer switch is not displayed. This parameter is available on switches that support VSX.
Authority
Operators or Administrators or local user group members with execution rights for this command. Operators can execute this command from the operator context (>) only.
Examples
switch# show loop-protect Status and Counters - Loop Protection Information Transmit Interval : 5 (sec) Port Re-enable Timer : Disabled Interface 1 Loop-protect enabled : Yes Loop-Protect enabled VLANs : Action on loop detection : TX disable Loop detected count : 0 Loop detected : No Interface status : up Interface 2 Loop-protect enabled : Yes Loop-Protect enabled VLANs : Action on loop detection : TX disable Loop detected count : 0 Loop detected : No Interface status : up
switch# show loop-protect 1 Status and Counters - Loop Protection Information Transmit Interval : 5 (sec) Port Re-enable Timer : Disabled Interface 1 Loop-protect enabled : Yes Loop-Protect enabled VLANs : Action on loop detection : TX disable Loop detected count : 0 Loop detected : No Interface status : up