`show vsx configuration {inter-switch-link | keepalive}`

Syntax

show vsx configuration {inter-switch-link | keepalive} [vsx-peer]

Description

Displays the ISL configuration or keepalive protocol configuration in VSX.

NOTE:

This show vsx configuration {inter-switch-link | keepalive} command replaces the show mclag configuration command that is supported only in 10.00 releases.

Command context

Operator (>) or Manager (#)

Parameters

{inter-switch-link | keepalive}

Selects inter-switch-link or keepalive.

inter-switch-link: Displays the ISL configuration in VSX.

keepalive: Displays the keepalive protocol configuration in VSX.

[vsx-peer]

Shows the output from the VSX peer switch. If the switches do not have the VSX configuration or the ISL is down, the output from the VSX peer switch is not displayed.

Authority

Operators or Administrators. Users without administrator authority can execute this command from the operator context (>) only.

Example

Displaying the ISL configuration in VSX:

switch# show vsx configuration inter-switch-link
Inter Switch Link   : 1/1/43
Hello Interval      : 1 Seconds
Dead Interval       : 20 Seconds
Hold Time           : 0 Seconds
Device Role         : primary
Multichassis LAGs   : lag 100

Displaying the keepalive protocol configuration in VSX:

switch# show vsx configuration keepalive
Keepalive Interface     : 1/1/1
Keepalive VRF           : test1
Source IP Address       : 192.168.1.1
Peer IP Address         : 192.168.1.2
UDP Port                : 7678
Hello Interval          : 1 Seconds
Dead Interval           : 3 Seconds