ipv6 address

Description

Sets an IPv6 address on the interface. To configure the interface as layer 3, use the routing command.

The no form of this command removes the IPv6 address on the interface.

Command context

config-if

Parameters

<IPV6-ADDR>

Specifies the IP address in IPv6 format (xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx), where x is a hexadecimal number from 0 to F. You can use two colons (::) to represent consecutive zeros (but only once), remove leading zeros, and collapse a hextet of four zeros to a single 0. For example, this address 2222:0000:3333:0000:0000:0000:4444:0055 becomes 2222:0:3333::4444:55.

<MASK>

Specifies the number of bits in the address mask in CIDR format (x), where x is a decimal number from 0 to 128.

Authority

Administrators

Examples

Setting the IPv6 address on interface 1/1/1 to 2001:0db8:85a3::8a2e:0370:7334 with a mask of 24 bits:

switch(config)# interface 1/1/1
switch(config-if)# ipv6 address 2001:0db8:85a3::8a2e:0370:7334/24

Removing the IP address 2001:0db8:85a3::8a2e:0370:7334 with mask of 24 bits on interface 1/1/1:

switch(config)# interface 1/1/1
switch(config-if)# no ipv6 address 2001:0db8:85a3::8a2e:0370:7334/24