vlan access

Description

Creates an access interface and assigns an VLAN ID to it. Only one VLAN ID can be assigned to each access interface.

VLANs can only be assigned to a non-routed (layer 2) interface or LAG interface. By default, all interfaces are routed (layer 3) when created. Use the no routing command to disable routing on an interface and change the interface to a layer 2 interface.

The no form of this command removes an access VLAN from the interface in the current context and sets it to the default VLAN ID of 1.

Command context

config-if

Parameters

<VLAN-ID>

Specifies the number of the VLAN ID to assign. The VLAN ID must exist. Range: 1 - 4040.

Authority

Administrators

Examples

Configuring interface 1/1/2 as an access interface with VLAN ID set to 20:

switch(config)# interface 1/1/2
switch(config-if)# no routing
switch(config-if)# vlan access 20

Removing VLAN ID 20 from interface 1/1/2:

switch(config)# interface 1/1/2
switch(config-if)# no vlan access 20

or:

switch(config)# interface 1/1/2
switch(config-if)# no vlan access