Comparing VLAN commands on PVOS, Comware, and ArubaOS-CX
The following examples compare the commands needed to implement typical VLAN configurations on different HPE products.
ArubaOS-CX
A native VLAN must be defined on the switch. By default, this is VLAN 1. Since only VLANs 10, 30 and 50 are allowed on the trunk, all untagged traffic is dropped. |
PVOS
|
Comware
PVID 1 is the default setting. |
ArubaOS-CX
Same as scenario 1, but allows untagged traffic on VLAN 10 as well. |
PVOS Not directly supported in PVOS. Scenario 1 is a workaround if there is no need to support untagged traffic. |
Comware Not directly supported in Comware. A possible workaround is:
|
ArubaOS-CX
VLAN 5 must be allowed on the trunk so that untagged traffic is not dropped. |
PVOS
|
Comware
|
ArubaOS-CX
|
PVOS
|
Comware
|