Changing OSPF trap generation choices

Optional: OSPF traps (defined by RFC 1850) are supported on the routing switches. OSPF trap generation is disabled by default, but you can use the following command to enable generation of any or all of the supported OSPF traps.

Syntax:


 trap [trap-name | all]

Used in the OSPF configuration context to enable or disable OSPF traps.

all

Enables or disables all OSPF traps available on the routing switch.

trap-name

Specifies a trap from table below to enable or disable.

The no form disables the specified trap.

Default: All OSPF traps disabled

The table below summarizes OSPF traps supported on the switches, and their associated MIB objects from RFC 1850.

Table 15: OSPF traps and associated MIB objects

OSPF trap name

MIB object

interface-authentication-failure ospflfAuthFailure
interface-config-error ospflfConfigError
interface-receive-bad-packet ospflfrxBadPacket
interface-retransmit-packet ospfTxRetransmit
interface-state-change

-

neighbor-state-change ospfNbrStateChange
originate-lsa ospfOriginateLsa
originate-maxage-lsa ospfMaxAgeLsa
virtual-interface-authentication-failure

-

virtual-interface-config-error ospfVirtlfConfigError
virtual-interface-state-change ospfVirtlfStateChange
virtual-neighbor-state-change ospfVirtNbrStateChange
virtual-interface-receive-bad-packet ospfVirtlfRxBad Packet
virtual-interface-retransmit-packet ospfVirtlfTxRetransmit

Example

Enabling OSPF traps

If you wanted to monitor the neighbor-state-change and interface-receive-bad-packet traps, you would use the following commands to configure the routing switch to enable the desired trap. The show command verifies the resulting OSPF trap configuration.

switch(ospf)# trap neighbor-state-change
switch(ospf)# trap interface-receive-bad-packet
switch(ospf)# show ip ospf traps

   OSPF Traps Enabled
   ================== 
      Neighbor State Change
      Interface Receive Bad Packet