Specifying the IP address to use as the source address for PIM protocol packets outbound on the VLAN

Syntax:


no ip pim-dense [ip-addr any | sourceip-address]

no vlan[vid]ip pim-dense [ip-addr | any | sourceip-address]

In networks using multinetted VLANs, all routers on a given VLAN intended to route multicast packets must have a least one common subnet on that VLAN. Use this command when the VLAN is configured with multiple IP addresses (multinetting) to specify the IP address to use as the source address for PIM protocol packets outbound on the VLAN.

  • Use ip-address to designate a single subnet in cases where multicast routers on the same multinetted VLAN are not configured with identical sets of subnet IP addresses.

  • Use all if the multinetted VLAN is configured with the same set of subnet addresses.

Default: the primary VLAN