Adjusting performance by changing the VLAN interface settings
The following OSPFv3 interface parameters are automatically set to their default values. No change to the defaults is usually required unless needed for specific network configurations.
Parameter |
Default |
Information |
---|---|---|
cost |
1 |
ipv6 ospf3 cost |
dead-interval |
40 seconds |
ipv6 ospf3 dead-interval |
hello-interval |
10 seconds |
ipv6 ospf3 hello-interval |
priority |
1 |
ipv6 ospf3 priority |
retransmit-interval |
5 seconds |
ipv6 ospf3 retransmit-interval |
transit-delay |
1 second |
ipv6 ospf3 transit-delay |
passive |
disabled |
ipv6 ospf3 passive |
Settings are configured on a per-interface basis.
NOTE:
Most of these parameters also apply to virtual link configurations. However, when used on a virtual link configuration, the OSPFv3 context requirement is different and the parameters are applied only to the interfaces included in the virtual link. See Adjusting virtual link performance by changing the interface settings.