Viewing a summary of OSPFv3 configuration information
Syntax
show ipv6 ospf3 [ general ]
Description
Displays the summary of OSPFv3 information, such as the areas configured, address ranges defined, interface information, timers, and virtual links.
Options
Example output
This example shows the output for show
ipv6 ospf3 command.
Switch# show ipv6 ospf3
OSPFv3 Configuration Information
OSPFv3 Protocol : Enabled
Router ID : 10.0.8.35
Currently defined areas:
Stub Stub Stub
Area ID Type Default Cost Summary LSA Metric Type SPF Runs
--------- ------ ------------ ----------- ------------- --------
backbone Normal 1 don’t send Ospfv3 Metric
10.3.16.0 Normal 1 don’t send Ospfv3 Metric
10.3.32.0 Normal 1 don’t send Ospfv3 Metric
Currently defined address ranges:
Prefix
AreaID LSAType Advt IPv6Addr
--------------- ---------- ------ --------------
OSPFv3 interface configuration:
Admin
Interface Area ID Status Type Cost Pri
---------- --------------- -------- ----- ----- ---
vlan-55 0.0.0.1 Enabled BCAST 1 1
vlan-75 0.0.0.1 Enabled BCAST 1 1
tunnel-3 0.0.0.0 Enabled P2P 1 1
OSPFv3 configured interface timers:
Transit Retransmit Hello Dead
Interface Delay Interval Interval Interval
---------- ------- ---------- -------- ----------
vlan-55 1 5 10 40
VLAN-75 1 5 10 40
tunnel-3 1 5 10 40
OSPFv3 configured virtual interfaces:
Xmit Rxmt Hello Dead
Transit AreaID Neighbor Router Delay Intvl Intvl Interval
--------------- --------------- ----- ----- ----- ----------
0.0.0.1 15.255.155.1 1 5 10 40