Customizing the show interfaces command (CLI)
You can create
show commands displaying the information that you want to see in any order you want by using the
custom option.
Syntax:
show interfaces custom [port-list]
column-list
Select the information that you want to display. Supported columns are shown in the table below.
Parameter column |
Displays |
Examples |
|---|---|---|
port |
Port identifier |
A2 |
type |
Port type |
100/1000T |
status |
Port status |
up or down |
speed |
Connection speed and duplex |
1000FDX |
mode |
Configured mode |
auto, auto-100, 100FDX |
mdi |
MDI mode |
auto, MDIX |
flow |
Flow control |
on or off |
name |
Friendly port name |
|
vlanid |
The vlan id this port belongs to, or "tagged" if it belongs to more than one vlan |
4tagged |
enabled |
port is or is not enabled |
yes or nointrusion |
intrusion |
Intrusion alert status |
no |
bcast |
Broadcast limit |
0 |
The custom show interfaces command
switch(config)# show int custom 1-4 port name:4 type vlan intrusion speed enabled mdi
Status and Counters - Custom Port Status
Intrusion
Port Name Type VLAN Alert Speed Enabled MDI-mode
---- ---------- ---------- ----- --------- ------- ------- --------
1 Acco 100/1000T 1 No 1000FDx Yes Auto
2 Huma 100/1000T 1 No 1000FDx Yes Auto
3 Deve 100/1000T 1 No 1000FDx Yes Auto
4 Lab1 100/1000T 1 No 1000FDx Yes Auto
You can specify the column width by entering a colon after the column name, then indicating the number of characters to display. In the above example, the Name column displays only the first four characters of the name. All remaining characters are truncated.
Each field has a fixed minimum width to be displayed. If you specify a field width smaller than the minimum width, the information is displayed at the minimum width. For example, if the minimum width for the Name field is 4 characters and you specify Name:2, the Name field displays 4 characters.
You can enter parameters in any order. There is a limit of 80 characters per line; if you exceed this limit an error displays.