CLI command error messages

Event

Message

Attempt to move a port into a trunk with a MAC ACL applied and there are not enough hardware resources available to accommodate the new port.

Operation failed on Port %s: General error.

Attempt to move a port with a MAC ACL applied to it into a trunk.

Unable to apply access control list. Port %s is part of a trunk.

Apply a MAC ACL to a vlan, interface or tunnel and there are not enough hardware resources available.

Unable to apply access control list. Failed to add entry %s.

Add a class to a policy and a non-matching class type is already applied IP/MAC)

Unable to add class. Policy cannot contain both IP and MAC classes.

Apply a MAC ACL on a vlan and it contains a rule that matches vlan-ID

Unable to apply access control list. ACLs applied to VLANs cannot match the VLAN ID parameter.

Apply a MAC Policy on a vlan and it contains a rule that matches vlan-ID

Unable to apply policy. Policies applied to VLANs cannot contain a class that matches the VLAN ID parameter.