tunneled-node-server
Syntax
tunneled-node-server [controller-ip <IP-ADDR|IPv6-ADDR> | backup-controller-ip
<IP-ADDR|IPv6-ADDR> | [keepalive <TIMEOUT>] | enable | mode role-based {reserved-vlan <VLAN-ID>}]
no tunneled-node-server [controller-ip <IP-ADDR|IPv6-ADDR> | backup-controller-ip
<IP-ADDR|IPv6-ADDR> | [keepalive <TIMEOUT>] | enable | mode role-based {reserved-vlan <VLAN-ID>}]Description
Configure tunneled node server information.
The no form of the command removes the tunneled node server configuration.
Parameters
- controller-IP
Configure the controller IP address for the tunneled node. Both IPv4 and iPv6 are supported.
- backup-controller-IP
Configure the backup controller IP address for the tunneled node. Both IPv4 and IPv6 are supported.
- keepalive
Configure the keepalive timeout for the tunneled node in seconds [1-40]. The default is 8 seconds.
- enable
Enter the manager command context.
- mode role-based
Specifies the tunneled node server mode as role based.
- mode role-based reserved-vlan
Specifies the VLAN used as tunneled node server reserved VLAN.
Examples
switch(config)# tunneled-node-server controller-ip 15.255.133.148switch(config)# tunneled-node-server backup-controller-ip 15.255.133.148switch(config)# tunneled-node-server keepalive 40