The TimeP Protocol

Enabling TimeP as the time protocol means configuring it for either DHCP or manual mode.

To run TimeP as the time synchronization protocol, you must also select TimeP as the time synchronization method by using the CLI timesync command or the menu interface Time Sync Method parameter.

Procedure
  1. To view the current time synchronization, enter show timep.
  2. Use the timesync command to set TimeP as the time synchronization mode:

    timesync timep

  3. Use the ip timep command to enable timep for dhcp or manual mode:

    ip timep dhcp|manual

  4. View the SNTP configuration again to verify the configuration.