Configuration setup

Syntax


[no] allow-v2-modules

Enables support for V2 modules. When enabled, V3 modules will operate in V2-compatiblity mode. When disabled, V3 modules will have full functionality and the ports of any V2 modules will be non-operable. Enabling the V2 module support erases the current configuration of the device and reboots the device. Whereas, disabling the V2 module support clears all V2 module specific configuration from startup configuration and reboots the device.

allow-v2-modules: Enable support for V2 modules.

Enabled/Disabled state

When V2 compatibility mode is disabled from an enabled state, the below message is displayed for user input.

Switch(config)# no allow-v2-modules
This command will disable all V2 modules and reboot the switch.
Continue (y/n)?

When V2 compatibility mode is enabled from disabled state, the below message is displayed for user input.

Switch(config)# allow-v2-modules
This command will erase the current configuration of the switch and reboot it.
Continue (y/n)?