Viewing tunnel configuration and status

The show interface tunnel list command displays information about the configuration and status of the specified tunnels.

Switch(config)# show interface tunnel 3,4

 Tunnel Configuration :

  Tunnel               : tunnel-3
  Tunnel Name          : Redtunnel
  Tunnel Status        : Enabled
  Source Address       : 120.22.33.44
  Destination Address  : 121.23.34.2
  Mode                 : 6in4
  TOS                  : 5            IPv6   : Enabled
  TTL                  : 100          MTU    : 1282

 Current Tunnel Status :

  Tunnel State                : Down
  Destination Address Route   : 0.0.0.0/0
  Next Hop IP                 : 15.255.128.1
  Next Hop Interface          : vlan-1
  Next Hop IP Link Status     : Up
  Source Address              : Not Configured
  IP Datagrams Received       : 0
  IP Datagrams Transmitted    : 0

 Tunnel Configuration :

  Tunnel                : tunnel-4
  Tunnel Name           : Blue_tunnel
  Tunnel Status         : Enabled
  Source Address        : 20.30.30.4
  Destination Address   : 10.20.20.3
  Mode                  : 6in4
  TOS                   : 10            IPv6  : Disabled
  TTL                   : 64            MTU   : 1280

Current Tunnel Status :
  Tunnel State               : Down
  Destination Address Route  : 0.0.0.0/0
  Next Hop IP                : 15.255.128.1
  Next Hop Interface         : vlan-1
  Next Hop IP Link Status    : Up
  Source Address             : Not Configured