Static routing overview
Static routes provide tools for restricting and troubleshooting routed traffic flows and in small networks can provide the simplest and most reliable configuration for IPv6 routing.
IPv6 network prefix for the route's destination network
- Next-hop gateway, which can be one of the following:
Either the link-local address and VLAN ID or the VLAN link to the next-hop router
Global unicast address on the next-hop router
A "null" interface (the routing switch drops traffic forwarded to the null interface)
Optionally, a nondefault administrative distance
To enable routing in both directions on a static route, you must configure reciprocal static routes on the routers at both ends of the route.
On a given routing switch you can create one static route or null route to a given destination. Multiple static or null routes to the same destination are not supported.
The routing switches can concurrently support a maximum of 256 IPv6 static routes and 256 IPv4 static routes.
Router "A" |
Router "B" |
Router "C" |
---|---|---|
ipv6 route2620:a::/64 2620:e::55:1 |
ipv6 route2620:a::/64 2620:b::22:1 |
ipv6 route2620:c::/64 2620:b::22:2 |
ipv6 route 2620:b::/642620:e::55:1 |
ipv6 route 2620:c::/64 2620:e::55:2 |
ipv6 route 2620:e::/64 2620:b::22:2 |
Note: Next-hop addresses can be either global unicast or link-local. |