vsf member shutdown

For a switch that physically exists, this command will cause the switch to shut down. shutdown is used in preparation to remove the switch from the virtual chassis. The switch will not become a voting member of the virtual chassis again until it is rejoined.

The shutdown command cannot be used on the Commander. The shutdown command will succeed only if the switch physically exists and is an active member of the virtual chassis.

Syntax

vsf member <MEMBER-ID> shutdown

Description

Shut down the VSF virtual chassis member.

Parameters

<MEMBER-ID>

The VSF member-ID for the member command or parameter. Member ID value can be in the range of 1 to 8.

Restriction

Shutdown will not be available until VSF is enabled.