LED 1 displays slow flash orange, LED 2 displays solid green, whereas, LED 3 displays different colors

Symptom

LED 1 displays slow flash orange and LED 2 displays solid green. LED 3 displays slow flash green, fast flash green, slow flash orange, or solid green.1

1 LED 1 is Global Status LED, LED 2 is Mode LED Usr, and LED 3 is Port LED.

Solution 1
Cause

The interface cable is connected to the VSF port on which the link LED is blinking.

Action
  1. Make sure that the stacking cable is fully connected at both ends of the link.
  2. If an equipment failure has occurred, see the LEDs on the device at the other end of the connection.
Solution 2
Cause
A stacking link failure has occurred on a link that was functioning:
  • The switch at the other end of the VSF port cable has been powered off.

  • The stacking feature is disabled on the switch at the other end of the VSF port cable.

  • The cable is faulty.

Action
  1. If this error occurred on an operational stack, it could result in changes to the stack configuration. This can include election of a new stack commander and possibly a new standby. Ensure that the correct set of supported cabling is used for installed transceivers or RJ45 fixed port.
  2. See the Stack Management chapter in the 2930F Advance Traffic Management Guide for more information. Contact your Hewlett Packard Enterprise authorized network reseller, or use the electronic support services from Hewlett Packard Enterprise to get assistance. See www.hpe.com/support/hpesc.