Configuring per-port MLD traffic filters

Syntax


ipv6 mld [auto port-list | blocked port-list | forward port-list]

Sets per-port traffic filters, which specify how each port should handle MLD traffic. Allowed settings are:

auto

Follows MLD snooping rules: packets are forwarded for joined groups.

blocked

All multicast packets are dropped, except that packets for well-known addresses are forwarded.

forward

All multicast packets are forwarded.

port-list

Specifies the affected port or range of ports.

The default value of the filter is auto.

NOTE:

This command must be issued in a VLAN context.

Configuring per-port MLD traffic filters

Switch(vlan-500)# ipv6 mld blocked 46-47
Switch# show ipv6 mld vlan 500 config

 MLD Service Vlan Config

  VLAN ID                               : 500
  VLAN NAME                             : VLAN500
  MLD Enabled [No]                      : Yes
  Querier Allowed [Yes]                 : Yes
  MLD Version                           : 2
  Strict Mode                           : No
  Last Member Query Interval (seconds)  : 10
  Robustness-Count                      : 2
  Port Type        Port Mode    Forced Fast Leave  Fast Leave  Fast Learn
  ------------------------------------------------------------------------
  1   100/1000T    forward      No                 Yes         No
  2   100/1000T    forward      No                 Yes         No
  3   100/1000T    forward      No                 Yes         No
  46  100/1000T    blocked      No                 Yes         No
  47  100/1000T    blocked      No                 Yes         No
  48  100/1000T    auto         No                 Yes         No

Switch#