Plug-and-go method
Install, but do not connect with stacking cables, a Stacking Module in each switch that will be in the stack, as described in the 2920 Installation and Getting Started Guide.
- Make sure that stacking is enabled for each switch.
Determine this by connecting a console to each switch and entering the command
show stacking
from the switch CLI.If stacking is disabled, enter the command
stacking enable
, which causes the switch to reboot.
NOTE:If you are connecting stacking cables during/after switch boot, then multiple stacks can form (plug-and-go method).By default, stacking is enabled on all switches when a Stacking Module is installed before the switch is powered up for the first time, but if the switches were powered up without a Stacking Module installed, stacking is disabled
Connect the stacking cables between the switches to form the desired stacking topology, then power on all switches.
When the switches that are stacked together complete booting up, one of the switches is elected as the Commander, one of the switches is elected as the Standby, the remaining switches become Members of the stack, and the stack becomes fully operational.
To find out the roles of the switches in the stack, connect a console to any switch and enter the
show stacking
command. You can use the MAC address and other information in the display to determine the role of each of the switches.