For IPv4

Syntax


show ip source-lockdown status

Output for the show ip source-lockdown status command is shown in the following example.

Output for the show ip source-lockdown status command

switch(config)# show ip source-lockdown status
 Dynamic IP Lockdown Status Information

Global State: Enabled

     Port     Operational State
     -------- ------------------
     1        Active
     2        Not in DHCP Snooping vlan
     3        Disabled
     4        Disabled
     5        Trusted port, Not in DHCP Snooping vlan
     . . . .  . . . . . . . . . . .