Viewing a summary of switch operational data

Syntax: 


show tech

By default, the show tech command displays a single output of switch operating and running-configuration data from several internal switch sources, including:

  • Image stamp (software version data)

  • Running configuration

  • Event Log listing

  • Boot history

  • Port settings

  • Status and counters — port status

  • IP routes

  • Status and counters — VLAN information

  • GVRP support

  • Load balancing (trunk and LACP)

The show tech command shows sample output from the show tech command.

The show tech command

switch# show tech

 show system

  Status and Counters - General System Information

   System Name        : Switch
   System Contact     :
   System Location    :

   MAC Age Time (sec) : 300

   Time Zone          : 0
   Daylight Time Rule : None

   Software revision  : XX.14.xx     Base MAC Addr  : 001871-c42f00
   ROM Version        : XX.12.12     Serial Number  : SG641SU00L

   Up Time            : 23 hours    Memory - Total :
   CPU Util (%)       : 10                    Free :

   IP Mgmt - Pkts Rx  : 759         Packet - Total : 6750
              Pkts Tx : 2             Buffers Free : 5086
                                            Lowest : 4961
                                            Missed : 0

show flash
Image       Size(Bytes)   Date  Version
-----       -----------  ------ --------

To specify the data displayed by the show tech command, use the copy show tech command.