fault-finder multicast-storm action
Syntax
fault-finder multicast-storm [action {warn | warn-and-disable}] [sensitivity {low | medium |high}]no fault-finder multicast-storm [action {warn | warn-and-disable}] [sensitivity {low | medium |high}]Description
Global command to configure multicast-storm. The
no form of the command disables multicast-storm configuration on the port. The default sensitivity is
medium and the default action is
warn.
Parameters
- warn
Log an event only
- warn-and-disable
Log an event and disable the port
- low
Low sensitivity
- medium
Medium sensitivity
- high
High sensitivity
Command context
config
Examples
switch(config)# fault-finder multicast-storm action warn sensitivity Configure the fault sensitivity level. switch(config)# fault-finder multicast-storm action warn sensitivity low Low sensitivity. medium Medium sensitivity. high High sensitivity. switch(config)# fault-finder multicast-storm action warn-and-disable sensitivity Configure the fault sensitivity level. switch(config)# fault-finder multicast-storm action warn-and-disable sensitivity low Low sensitivity. medium Medium sensitivity. high High sensitivity. switch(config)# fault-finder multicast-storm action warn-and-disable sensitivity high
Global
show command for auto-100 duplex Smart Rate port:
switch(config)# show fault-finder Fault Finder Fault ID Sensitivity Action ------------------- ----------- ---------------- bad-driver medium warn bad-transceiver medium warn bad-cable medium warn too-long-cable medium warn over-bandwidth medium warn broadcast-storm medium warn loss-of-link medium warn duplex-mismatch-hdx medium warn duplex-mismatch-fdx medium warn multicast-storm high warn-and-disable link-flap medium warn