Changing the operation Reset+Clear combination

In their default configuration, using the Reset+Clear buttons in the combination described under Restoring the factory default configuration replaces the switch current startup-config file with the factory default startup-config file, then reboots the switch and removes local password protection.

CAUTION:

Anyone with physical switch access can use this button combination to replace the switch current configuration with the factory default configuration, and render the switch accessible without the need to input a username or password.

You can use the factory-reset command to prevent the Reset+Clear combination from being used for this purpose.

Syntax:


front-panel-security factory-reset
no front-panel-security factory-reset

Disables or re-enables the following functions associated with using the Reset+Clear buttons in the combination described under Restoring the factory default configuration:

Replacing the current startup-config file with the factory default startup-config file
Clearing any local usernames and passwords configured on the switch

Default: Both functions enabled.

NOTE:

The Reset+Clear button combination always reboots the switch, regardless of whether the no form of the command has been used to disable the above two functions. Also, if you disable factory-reset, you cannot disable the password-recovery option, and the reverse.