cdp mode pre-standard-voice
Syntax
[no] cdp mode pre-standard-voice [admin-status <PORT-LIST> [tx_rx | rxonly]]
Description
Enable CDP-compatible voice VLAN discovery with pre-standard VoIP phones. In this mode, when a CDP VoIP VLAN query is received on a port from pre-standard phones, the switch replies back with a CDP packet that contains the VID of the voice VLAN associated with that port.
Not recommended for phones that support LLDP-MED.
Parameters and options
pre-standard-voice
Enables CDP-compatible voice VLAN discovery with pre-standard VoIP phones.
admin-status
Sets the port in either transmit and receive mode, or receive mode only.
Default: tx-rx.
<PORT-LIST>
Sets this port in transmit and receive mode, or receive mode only.
rxonly
Enable receive-only mode of CDP processing.
tx_rx
Enable transmit and receive mode.
cdp mode pre-standard-voice
Switch# cdp mode pre-standard-voice admin-status A5 rxonly
show cdp without cdp run
CDP Run
is disabled.
Switch(config)# show cdp Global CDP information Enable CDP [yes] : no
show cdp with cdp run and sdp
show cdp
output when
cdp run
and
sdp mode
are enabled.
Switch# show cdp Global CDP Information Enable CDP [Yes] : Yes CDP mode [rxonly] : pre-standard-voice CDP Hold Time [180] : 180 CDP Transmit Interval [60] : 60 Port CDP admin-status ---- --------- ------------ A1 enabled rxonly A2 enabled tx_rx A3 enabled tx_rx
show cdp with cdp run and cdp mode rxonly
show cdp
output when
cdp run
and
cdp mode rxonly
are enabled. When CDP mode is not
pre-standard voice
, the admin-status column is note displayed.
switch# show cdp Global CDP Information Enable CDP [Yes} : Yes CDP mode [rxonly] : rxonly Port CDP ---- -------- A1 enabled A2 enabled A3 enabled
show running-config
show running-config
when admin-status is configured.
switch# show running-config Running configuration: ; J9477A Configuration Editor; Created on release #K.16.09.0000x ; Ver #03:01:1f:ef:f2 hostname “Switch” module 1 type J9307A cdp mode pre-standard-voice admin-status A5 RxOnly