show mac-count-notify
Syntax
show mac-count-notify traps [<PORT-LIST>]Description
Displays information about the configured value for sending a trap, the current count, and if a trap has been sent.
Command output
switch(config)# show mac-count-notify traps
Mac-count-notify Enabled: Yes
Port Count for Count Trap Sent
sending Trap
-----------------------------------------------------------------
1
2
3
4
5 50 0 No
6 50 2 No
7 50 0 No
8
9
...
Configuring mac-count-notify traps from the interface context
The interface context can be used to configure the value for sending a trap.
switch(config)# interface 5
switch(eth-5)# mac-count-notify traps 35
View information about SNMP traps, including MAC address count being Enabled/Disabled
The
show snmp-server traps command displays whether the MAC Address Count feature is enabled or disabled.
switch# show snmp-server traps Trap Receivers Link-Change Traps Enabled on Ports [All] : All Traps Category Current Status _____________________________ __________________ SNMP Authentication : Extended Password change : Enabled Login failures : Enabled Port-Security : Enabled Authorization Server Contact : Enabled DHCP-Snooping : Enabled Dynamic ARP Protection : Enabled Dynamic IP Lockdown : Enabled MAC address table changes : Disabled MAC Address Count : Enabled Address Community Events Type Retry Timeout ---------------------- ---------------------- -------- ------ ------- ------- 15.146.194.77 public None trap 3 15 15.255.134.252 public None trap 3 15 16.181.49.167 public None trap 3 15 16.181.51.14 public None trap 3 15 Excluded MIBs