Validation rules for VSF member

Validation

Error/Warning/Prompt

When trunk static/manual and mesh is getting configured as VSF port

  • Cannot configure VSF on port "A1" because that port is an LACP trunk.

  • Cannot configure VSF on port "A1" because that port is a Mesh.

  • Cannot configure VSF on port "A1" because that port is a Distributed LACP trunk.

  • Cannot configure VSF on port "A1" because that port is a Distributed trunk.

  • Cannot configure VSF on port "A1" because that port is a Dynamic trunk.

  • Cannot configure VSF on port "A1" because that port is an InterSwitch Connect (ISC) portError configuring VSF on port "A1": An unsupported trunking mode is already configured on this port.

Adding a 1G port to a VSF link

Cannot enable VSF on a port operating at other than 10G or 40G.

Adding both 10G and 40G ports to a VSF link

Port 1/A1 does not support the current VSF port speed of 10G and may not be activated. Use compatible transceiver or reconfigure port speed to utilize this port.

All configuration on this port has been removed and port is placed in VSF mode.

Max 8 ports per link.

Cannot configure more than 8 physical ports as an VSF link.

For other than physical ports.

VSF capabilities are not supported on port "A1".

Cannot set a link name which is having more than 10 characters.

Cannot configure the VSF link name. The name is not a valid UI display string, or is blank, or exceeds 10 characters.

Direct VSF port removal case

Cannot remove VSF link when it has physical ports associated with it. First remove the associated physical ports and then remove the VSF link.

Removing the last VSF port in a VSF link that is "Up" is forbidden.

Removing of binding between physical ports and VSF link is not allowed since it would result in a stack split.

Using a port reserved for internal use as a VSF port.

Cannot use stolen/reserved ports as VSF ports.