allow-v2-modules
Syntax
allow-v2-modulesDescription
Enables the use of v2 modules in the switch. Before enabling v2 support, the command determines whether any of the v3-native features are configured. This command is active only in v3–native mode.
V3 modules cannot be changed
to v2-compatibility mode when there are v3-specific configuration
settings. Use the command 'show running-config v3-specific'
to display the settings that must be changed before enabling v2 module
support.
Unconfigure all v3-only features before moving to compatibility mode.
If the v3-native configuration is not present,
the device reboots with the non-v3 configuration and issues the following
message:This command will save the
running configuration and reboot the system with all V3 modules operating
in v2-compatibility mode.Continue (y/n)?
Options
- erase
Erases the entire configuration and reboots the switch with either the custom default configuration (if it is available) or the factory default configuration. The command with the erase option is active only in v3–native mode.
Usage
allow-v2-modules eraseMore Information
To list the v3-native configurations present in the current configuration, see show running-config v3-specific.