IP global parameters for routing switches

The following table lists the IP global parameters and the page where you can find more information about each parameter.

IP global parameters for routing switches

Parameter

Description

Default

See page

Address Resolution Protocol (ARP)

A standard IP mechanism that routers use to learn the MAC address of a device on the network. The router sends the IP address of a device in the ARP request and receives the device's MAC address in an ARP reply.

Enabled

Configuring ARP parameters

ARP age

The amount of time the device keeps a MAC address learned through ARP in the device's ARP cache. The device resets the timer to zero each time the ARP entry is refreshed and removes the entry if the timer reaches the ARP age. See ARP age timer .

Five minutes

N/A

Time to Live (TTL)

The maximum number of routers (hops) through which a packet can pass before being discarded. Each router decreases a packet's TTL by 1 before forwarding the packet. If decreasing the TTL causes the TTL to be 0, the router drops the packet instead of forwarding it.

64 hops

See the chapter "Configuring IP Addressing" in the Management and Configuration Guide.

Directed broadcast forwarding

A directed broadcast is a packet containing all ones (or in some cases, all zeros) in the host portion of the destination IP address. When a router forwards such a broadcast, it sends a copy of the packet out each of its enabled IP interfaces.
NOTE:

You also can enable or disable this parameter on an individual interface basis. See IP interface parameters for routing switches.

Disabled

Enabling forwarding of IP directed broadcasts (CLI)

ICMP Internet Router Discovery Protocol (IRDP)

An IP protocol that a router can use to advertise the IP addresses of its router interfaces to directly attached hosts. You can enable or disable the protocol at the Global CLI Config level. You also can enable or disable IRDP and configure the following protocol parameters on an individual VLAN interface basis at the VLAN Interface CLI Config level.
  • Forwarding method (broadcast or multicast)

  • Hold time

  • Maximum advertisement interval

  • Minimum advertisement interval

  • Router preference level

Disabled

Configuring IRDP

Static route

An IP route you place in the IP route table.

No entries

Static route types

Default network route

The router uses the default network route if the IP route table does not contain a route to the destination. Enter an explicit default route (0.0.0.0 0.0.0.0 or 0.0.0.0/0) as a static route in the IP route table.

None configured

Configuring the default route