Including friendly port names in per-port statistics listings (CLI)

Syntax:


show interface <port-number>

Includes the friendly port name with the port's traffic statistics listing. A friendly port name configured to a port is automatically included when you display the port's statistics output.

If you configure port A1 with the name "O'Connor_10.25.101.43," the show interface output for this port appears similar to the following:

A friendly port name in a per-port statistics listing

switch(config)# show interface a1
 Status and Counters - Port Counters for port A1

  Name  : O’Connor@10.25.101.43
  MAC Address     : 001871-b995ff
  Link Status     : Up
  Totals (Since boot or last clear) :
   Bytes Rx       : 2,763,197          Bytes Tx       : 22,972
   Unicast Rx     : 2044               Unicast Tx     : 128
   Bcast/Mcast Rx  : 23,456            Bcast/Mcast Tx : 26
  Errors (Since boot or last clear) :
   FCS Rx         : 0                  Drops Tx       : 0
   Alignment Rx    : 0                 Collisions Tx  : 0
   Runts Rx       : 0                  Late Colln Tx  : 0
   Giants Rx      : 0                  Excessive Colln : 0
   Total Rx Errors : 0                 Deferred Tx    : 0
  Others (Since boot or last clear) :
   Discard Rx     : 0                  Out Queue Len  : 0
   Unknown Protos  : 0
  Rates (5 minute weighted average) :
   Total Rx (bps) : 3,028,168          Total Tx  (bps) : 1,918,384
   Unicast Rx (Pkts/sec) : 5           Unicast Tx (Pkts/sec) : 0
   B/Mcast Rx (Pkts/sec) : 71          B/Mcast Tx (Pkts/sec) : 0
   Utilization Rx  : 00.30 %           Utilization Tx : 00.19 %

For a given port, if a friendly port name does not exist in the running-config file, the Name line in the above command output appears as:

Name :