show access-list command

The existing “show access-list” command will have the following modification to support ip- directed-broadcast.

Syntax 


show access-list

Options

  • <ACL-ID> [config]
  • <config>
  • <ip-directed-broadcast>
  • ports <<PORT-LIST>>
  • <radius>
  • <resources>

Show Access Control List Information.

NOTE:

Please note that the existing help of all other parameters listed other than newly added ip-directed-broadcast will remain the same.

Show ACL’s applied to IP Directed Broadcast traffic


show access-list <ip-directed-broadcast>

switch # show access-list ip-directed-broadcast

Access Lists for IP Directed Broadcast
IPv4                   : wol-acl   Type: Extended

If user uses already existing show access-list <ACL_NAME-STR> command, the status of ACL on IP Directed Broadcast will be shown applied as in this example below. 

switch # sh access-list wol-acl
Access Control Lists
.......Name: wol-acl
 ......Type: Extended
.......Applied: Yes
.......SEQ  Entry
-----------------------------------------------------------------------------
10  .Action: permit
 ......Src IP: 192.168.1.1       Mask: 255.255.255.0     Port(s):
.......Dst IP: 182.168.1.1       Mask: 55.255.255.0      Port(s):
.......Proto : IP
 ......TOS   : -                 Precedence: -
20  Action: deny
.......Src IP: 172.168.1.1       Mask: 255.255.255.0     Port(s):
.......Dst IP: 162.168.1.1       Mask: 255.255.255.0     Port(s):
 ......Proto : IP
 ......TOS   : -                 Precedence: -