OSPF global and interface settings
When first enabling OSPF, you may want to consider configuring ranges and restricting redistribution (if an ASBR is used) to avoid unwanted advertisements of external routes. You may also want to enable the OSPF trap and authentication features to enhance troubleshooting and security. However, Hewlett Packard Enterprise generally recommends that the remaining parameters with non-null default settings be left as-is until you have the opportunity to assess OSPF operation and determine whether any adjustments to non-default settings is warranted.
Set global level parameters in the ospf context of the CLI. To access this context level, ensure that routing
is enabled, then execute router ospf at the global
CONFIG level. For example:
switch (config)# router ospf switch (ospf)#
Use the VLAN interface context to set interface
level OSPF parameters for the desired VLAN. To access this context
level, use vlan vid either to move to the VLAN
context level or to specify that context from the global config level.
For example, both of the following command sets achieve the same result:
switch(config)# vlan 20 switch(vlan-20)# cost 15
switch(config)# vlan 20 cost 15