ip source-interface tunneled-node-server
Syntax
switch(config)# ip source-interface tunneled-node-server
[<IP_ADDRESS> | loopback <LOOPBACK_INTERFACE> | vlan <VLAN_ID>]
Description
Defines source IP address or interface for specified protocol.
NOTE:
If interface has multiple addresses, lowest address is used.
Protocols not configured with a specific address will use the IP address of outbound interface as source.
Command context
ip source-interface
Parameters
<IP_ADDRESS>
Specifies IP address.
<LOOPBACK_INTERFACE>
Specifies a loopback interface.
<VLAN_ID>
Specifies VLAN ID.
Example
Running configuration:
NOTE:
Requires
(config)#show run
context:
; J9850A Configuration Editor; Created on release #KB.16.05.0000x ; Ver #12:08.1f.fb.7f.bf.bb.ff.7c.59.fc.7b.ff.ff.fc.ff.ff.3f.ef:f4 hostname "Anay5400R" module A type j9989a module B type j9986a module C type j9989a module D type j9986a module E type j9986a module F type j9986a class ipv4 "testclass" 10 match ip 0.0.0.0 255.255.255.255 0.0.0.0 255.255.255.255 20 match tcp 0.0.0.0 255.255.255.255 0.0.0.0 255.255.255.255 exit policy user "testpolicy" 10 class ipv4 "testclass" action permit exit radius-server host 90.90.90.1 ip routing ip source-interface tunneled-node-server loopback 1 tunneled-node-server controller-ip 21.1.1.2 mode role-based exit