Configuring security settings using the CLI wizard

To configure the security settings using the CLI wizard, follow the steps below:

Procedure
  1. At the command prompt, type setup mgmt-interfaces.
  2. The welcome banner appears and the first setup option is displayed (Operator password). As you advance through the wizard, each setup option displays the current value in brackets [ ] as shown here:
    Management Interface wizard configuration
  3. When you enter the wizard, you have the following options:
    1. To update a setting, type in a new value, or press Enter to keep the current value.
    2. To quit the wizard without saving any changes, press CTRL+C at any time.
    3. To access online Help for any option, press ?. After you have gone through each setup option, the wizard displays the summary configuration together with a prompt to save the changes, see Management Interface wizard configuration for an example.
  4. When the message appears asking if you want to save these changes, you have the following options:
    1. To save your changes, press Enter.
    2. To cancel any changes without saving, enter n and then press Enter. After pressing Enter, the wizard exits to the command line prompt.