Disabling time synchronization without changing the TimeP configuration (CLI)
Syntax:
no timesync
Disables time synchronization by changing the
Time Sync Mode
configuration to
Disabled
. This halts time synchronization without changing your TimeP configuration. The recommended method for disabling time synchronization is to use the
timesync
command.
Example:
Suppose TimeP is running as the switch's time synchronization protocol, with
DHCP
as the TimeP mode, and the factory-default polling interval. You would halt time synchronization with this command:
switch(config)# no timesync
If you then viewed the TimeP configuration, you would see the following:
TimeP with time synchronization disabled
switch(config)# show timep Timep Configuration Time Sync Mode: Disabled TimeP Mode : DHCP Poll Interval (min): 720