ipv6 ospf3 passive
Syntax
ipv6 ospf3 passive
no ipv6 ospf3 passive
Description
VLAN context command for enabling or disabling passive OSPFv3 operation on the VLAN.
The
no
option returns the VLAN interface to active OSPFv3 operation.
Default: OSPFv3 active
Example output
This example shows how to configure an OSPF3v3 interface as passive. Enter this command in the VLAN context:
Switch(vlan-1)# ipv6 ospf3 passive
To display the OSPFv3 passive information, enter the command shown in below:
show ipv6 ospf3 interface command with passive configured on an interface
Switch(config)# show ipv6 ospf3 interface OSPFv3 configuration and statistics for interfaces Interface Status Area ID State Cost Pri Passive ---------- -------- --------- ------- ----- ----- ------- vlan-55 Enabled 0.0.0.1 BDR 1 1 No vlan-75 Enabled 0.0.0.3 BDR 1 1 Yes
show ipv6 ospf3 interface command for a specific VLAN with passive configured on an interface
You can display the OSPFv3 passive information for a particular VLAN: suppose that a routing switch has OSPFv3 configured on VLAN 75. The following example shows a detailed output for VLAN 75 alone.
Switch(config)# show ipv6 ospf3 interface VLAN 75 detail OSPFv3 configuration and statistics for VLAN 75 Interface : vlan-75 Status : Enabled Area ID : 0.0.0.3 State : WAIT Priority : 1 Cost : 1 Type : BCAST Passive : Yes Hello Interval : 10 Dead Interval : 40 Transit Delay : 1 Retransmit Interval : 5 Events : 0 Designated Router : 15.1.1.2 Neighbors : 1 Backup Designated Router : 15.1.4.4