Commands for configuring IPv6 address

In the default configuration on a VLAN, any of the following commands enables IPv6 and creates a link-local address. Thus, while any of these methods is configured on a VLAN, IPv6 remains enabled and a link-local address is present.

ipv6 enable

(See ipv6 enable.)

ipv6 address autoconfig

(See Enable auto configuration of a global unicast address and a default router identity on a VLAN.)

ipv6 address dhcp full [rapid-commit]

(See ipv6 address dhcp full.)

ipv6 address fe80:0:0:0: <interface-identifier> link-local

(See ipv6 address link-local.)

ipv6 address <prefix:interface-identifier>

(See Commands to statically configure a global unicast address.)