Converting a Dynamic VLAN to a Static VLAN

If a port on the switch has joined a dynamic VLAN, you can use the following command to convert that dynamic VLAN to a static VLAN:

static dynamic-vlan-id

Converts a dynamic, port-based VLAN membership to a static, port-based VLAN membership (allows port-based VLANs only).

For this command, vlan-id refers to the VID of the dynamic VLAN membership. Use show vlan to help identify the VID.

This command requires that GVRP is running on the switch and a port is a dynamic member of the selected VLAN.

After you convert a dynamic VLAN to static, you must configure the switch's per-port participation in the VLAN in the same way that you would for any static VLAN.

Converting a dynamic VLAN 333 to a static VLAN

When converting a dynamic VLAN to a static VLAN as shown here, all ports on the switch are assigned to the VLAN in Auto mode.

switch(config)# static 333